Rohde & Schwarz ESW Series - Display Layout and Elements

Remote Commands in the Receiver Application
R&S
®
ESW
641User Manual 1177.6298.02 ─ 08
15.9.5 Display Layout and Elements
● Screen Element Selection.....................................................................................641
● Colors and Schemes.............................................................................................644
● CMAP Suffix Assignment......................................................................................646
15.9.5.1 Screen Element Selection
Commands to configure screen elements described elsewhere.
●
DISPlay[:WINDow<n>]:MTABle on page 542
●
DISPlay:FORMat on page 517
DISPlay:ANNotation:CBAR............................................................................................. 641
DISPlay:ANNotation:FREQuency.....................................................................................641
DISPlay:ITERm[:STATe]..................................................................................................641
DISPlay:SBAR[:STATe]...................................................................................................642
DISPlay:SKEYs[:STATe]................................................................................................. 642
DISPlay:TBAR[:STATe]................................................................................................... 642
DISPlay:TOUChscreen[:STATe]....................................................................................... 642
DISPlay[:WINDow<n>]:TIME...........................................................................................643
DISPlay[:WINDow<n>]:TIME:FORMat..............................................................................643
INPut:TERMinator..........................................................................................................644
SYSTem:DISPlay:FPANel[:STATe]................................................................................... 644
DISPlay:ANNotation:CBAR <State>
This command hides or displays the channel bar information.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DISP:ANN:CBAR OFF
Manual operation: See "Channel Bar" on page 308
DISPlay:ANNotation:FREQuency <State>
This command turns the label of the x-axis on and off.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DISP:ANN:FREQ OFF
Manual operation: See "Diagram Footer (Annotation)" on page 308
DISPlay:ITERm[:STATe] <State>
This command turns the display of the "Disconnect RF" icon on the toolbar on and off.
General Instrument Setup