Setting Up the Instrument
R&S
®
ETL
15Getting Started 2118.4130.02 ─ 04
Risk of injury when stacking instruments
A stack of instruments can tilt over and cause injury if not stacked correctly. Further-
more, the instruments at the bottom of the stack can be damaged due to the load
imposed by the instruments on top.
Observe the following instructions when stacking instruments:
●
Place the bottom instrument on a stable, flat and level surface with the bottom of
the instrument facing down.
●
Stack the instruments according to their size and weight, with the largest and heav-
iest instrument at the bottom.
●
Never stack more than three instruments. If you need to stack more than three
instruments, install them in a rack.
To adjust the handle position
1. Pull at both side knobs and turn the handle as shown in Figure 4-1.
2. When the handle is in the desired position, loose your hold on both side knobs.
Figure 4-1: Moving the handle of the R&S
ETL
Putting Up the Instrument
To Next Page
Loading...
