Interfaces and Connectors
R&S
®
ETL
33Getting Started 2118.4130.02 ─ 04
Figure 5-3: Pin assignment
Pin Signal Description
1 +5 V / max. 250 mA Supply voltage for external circuits
2 to 7 I/O Reserved for future use
8 GND Ground
9 READY FOR TRIG-
GER
Signal indicating that the R&S ETL is ready to receive trigger signal
(low active = 0 V).
Risk of instrument damage
A short-circuit may damage the R&S ETL. Take care to assign the pins correctly.
5.2.7 AV Decoder and TS Processing (B380)
Optional; installed in slot 6, see Figure 5-2.
Decodes TV programs and displays them either on the R&S ETL display or on an
external monitor. Additionally enables software options for:
●
Analyzing MPEG2 transport streams (MPEGTS Analyzer/Monitoring option,
R&S ETL-K282)
●
Generating and recording MPEG2 transport streams (MPEGTS Generator/
Recorder option, R&S ETL-K280)
●
Inputting and outputting transport streams using a 1000 BASE-T Ethernet connec-
tor and RTP/UDP protocol (IP Input and Output option, R&S ETL-K386).
HDMI OUT
19 pin, female HDMI (high-definition multimedia interface) connector, in line with the
HDMI 2.0 standard.
At this output, digital video and audio signals are provided for an external monitor. It is
not possible to simultaneously display the video on the R&S ETL display.
Rear Panel
To Next Page
Loading...
