Interfaces and Connectors
R&S
®
ETL
34Getting Started 2118.4130.02 ─ 04
Electromagnetic interference (EMI) can affect the measurement results. To avoid any
impact, make sure that the conditions described in Chapter 6.1, "Preventing Electro-
magnetic Interference", on page 37 are met.
DVB COMMON INTERFACE
Receptacle for a conditional access module (CAM) in line with the European EN50221
standard.
A suitable CAM inserted here decrypts a service for decoding, playing and outputting
protected video and audio content.
TS ASI IN
Female BNC connector for an asynchronous serial interface (ASI) in line with
EN50083-9 or a SMPTE 310 M interface.
At this connector, an external MPEG2 transport stream can be input for decoding,
analysis (R&S ETL-K282) and recording (R&S ETL-K280).
TS ASI OUT
Female BNC connector for an asynchronous serial interface (ASI) in line with
EN50083-9.
At this output, an MPEG2 transport stream is provided from the following sources:
●
TS generator/recorder (R&S ETL-K280)
●
TS IN / OUT 1000 BASE-T connector (R&S ETL-K386)
●
TS ASI IN connector.
●
Internal demodulator
TS IN / OUT 1000 BASE-T
1000 BASE-T Ethernet connector to input and output transport streams in line with the
SMPTE2022-1/2 standard ( R&S ETL-K386).
At this connector, up to two transport streams can be input for decoding, analysis
(R&S ETL-K282) and recording (R&S ETL-K280).
Simultaneously, up to two transport streams can be output from the following sources:
●
TS Generator/Recorder (R&S ETL-K280)
●
TS IN / OUT 1000 BASE-T connector (R&S ETL-K386)
●
TS ASI IN connector
●
Internal demodulator
5.2.8 MPEG Processing Board (B280)
Optional, installed in slot 6, see Figure 5-2.
Legacy option, replaced by Chapter 5.2.7, "AV Decoder and TS Processing (B380)",
on page 33.
Rear Panel
To Next Page
Loading...
