Interfaces and Connectors
R&S
®
ETL
35Getting Started 2118.4130.02 ─ 04
Extends the functionality of the R&S ETL to analyze (R&S ETL-K282) and generate
(R&S ETL-K280) MPEG-2 Transport Streams. Additionally, the MPEG Processing
Board option can include the R&S ETL-B281 (Video/ Audio Hardware Decoder) option.
An R&S ETL also fitted with this option provides functionality to decode TV programs
(SDTV and HDTV) within an MPEG-2 Transport Stream.
DVB COMMON INTERFACE
Ready for future applications. The pin assignment is conform to the European standard
EN50221.
TS ASI IN
The female BNC connector is used as ASI (Asynchronous Serial Interface) conform to
EN50083-9.
For the MPEG analysis (MPEG-TS Analyzer/Monitoring option, R&S ETL-K282), the
external MPEG-2 Transport Stream is input at this connector.
TS ASI OUT
The female BNC connector is used as ASI (Asynchronous Serial Interface) conform to
EN50083-9.
The MPEG-2 Transport Stream (output signal) is generated by the MPEG-TS Genera-
tor / Recorder option (R&S ETL-K280).
HDMI OUT
The 19 pin, female HDMI (High-Definition Multimedia Interface) is the interface for digi-
tal video and audio output. The pin assignment is conform to the HDMI 1.1 standard.
Electromagnetic interference (EMI) can affect the measurement results. To avoid any
impact, make sure that the conditions described in Chapter 6.1, "Preventing Electro-
magnetic Interference", on page 37 are met.
The output signal is generated by the Video/ Audio Hardware Decoder option
(R&S ETL-B281).
5.2.9 Li-Ion Battery Pack (B235)
Optional; installed in slot 6, see Figure 5-2.
Rear Panel
To Next Page
Loading...
