Instrument Tour
R&S
®
FPL1000
38Getting Started 1323.1602.02 ─ 07
Function key Assigned functions
[Sweep] Sets the sweep time and the number of measurement points
Selects continuous measurement or single measurement
[Trace] Configures the graphical analysis of the measurement data
[Meas] Provides the measurement functions:
Measurement of multicarrier adjacent channel power (Ch Power
ACLR)
Carrier to noise spacing (C/N C/N
0
)
Occupied bandwidth (OBW)
Spectrum emission mask measurement (Spectrum Emission
Mask)
Spurious emissions (Spurious Emissions)
Measurement of time domain power (Time Domain Power)
Third-order intercept point (TOI)
AM modulation depth (AM Mod Depth)
[Meas Config] Used to configure measurements and data input and output
[Lines] Configures display lines and limit lines
[Mkr] Sets and positions the absolute and relative measurement mark-
ers (markers and delta markers)
Selects special marker functions
[Mkr->] Used for search functions of the measurement markers (maxi-
mum/minimum of the trace)
Assigns the marker frequency to the center frequency, and the
marker level to the reference level
Restricts the search area (Search Limits) and characterizes the
maximum points and minimum points (Peak Excursion)
[Trig] Sets the trigger mode, the trigger threshold, the trigger delay, and
the gate configuration for gated sweep
[Peak] Performs a peak search for active marker. If no marker is active,
normal marker 1 is activated and the peak search is performed
for it.
[Run Single] Starts and stops a single new measurement (Single Sweep
Mode)
[Run Cont] Starts and stops a continuous measurement (Continuous Sweep
Mode)
Front Panel View
To Next Page
Loading...
