R&S FSH Working with the Measurement Wizard
Using the Measurement Wizard
Operating Manual 1173.6275.12 - 30 48
- Skip a measurement ("Skip Meas" softkey).
Skips a single measurement and initiates the subsequent measurement.
Skipping individual measurements is possible when you turn on "Allow to skip
measurements and finish wizard sequence" in the "Wizard Set Editor" of the
R&S FSH4View software.
- End the measurement sequence ("Finish Wizard" softkey).
Ends the measurement sequence and returns to the "Measurement Wizard"
dialog box. The results of the measurements you have already finished are
kept in the memory of the R&S FSH.
Ending the sequence is possible when you turn on "Allow to skip
measurements and finish wizard sequence" in the "Wizard Set Editor" of the
R&S FSH4View software.
- Abort the measurement sequence ("Cancel" softkey).
Aborts the measurement and returns to the "Measurement Wizard" dialog box.
The results of the measurements you have already finished are lost.
When you have finished all measurements that are part of the measurement set, the
R&S FSH asks you if you want to save the measurement results.
► Press the "Save Meas Results" softkey.
The R&S FSH saves the results on the selected storage device.
Limited internal memory
If you have to store the results on the internal memory, make sure that it has enough
space left to store them. Else the results might get lost. If the space is not enough, you
can delete old data with the file manager.
For more information see "Deleting Datasets" on page 38.
The results for a measurement set consist of a number of files, each file corresponding
to one of the performed measurements. For easy evaluation, the R&S FSH includes
the name of the measurement as defined in the wizard dialog or R&S FSH4View in the
file name.
All result files that belong to a measurement set are stored in the same directory. The
directory is named after the measurement name and site. The syntax is
'sitename_measurement_#'.
The R&S FSH adds numbers in ascending order to files as well as directories if you
perform a measurement or measurement set more than once.
To Next Page
Loading...
