R&S FSH3 Setting and Using the Measurement Functions
Standard
Power readout
Measurement time
Trigger
level
Measurement
Limits
Selecting a standard:
When the function is switched on, the R&S FSH3 automatically selects the GSM/EDGE standard. All
default settings are selected so that power measurements on GSM or EDGE bursts give true readings.
A different default setting can be configured with USER.
¾ Press the STANDARD softkey.
¾ Using the rotary knob or the cursor keys, select the
USER menu item.
¾ Confirm your selection with the ENTER key or the
STANDARD softkey.
The USER STANDARD settings that have already
been stored are set on the R&S FSH3. When the
USER STANDARD is called for the first time, it sets
the measurement parameters for the GSM/EDGE
standard.
If the USER STANDARD is set, the R&S FSH3
automatically accepts all measurement parameter
changes so that they are available next time USER
STANDARD is selected.
Setting the measurement time:
The measurement time (MEAS TIME) is the time over which the R&S FSH3 performs a power
measurement. A value less than or equal to the sweep time can be selected.
1145.5973.12 4.37 E-6
To Next Page
Loading...
