Rohde & Schwarz FSH4 - Page 17

R&S FSH Table of Contents
Operating Manual 1173.6275.12 - 30 2
2.2 Using the Measurement Wizard ...............................................................................44
2.2.1 Starting the Measurement Wizard ...............................................................................44
2.2.2 Performing a Sequence of Measurements ..................................................................46
2.3 Evaluating Results .....................................................................................................49
3 Spectrum Analyzer Mode ................................................................. 50
3.1 Performing Spectrum Measurements ......................................................................50
3.1.1 Measuring Basic Signal Characteristics ......................................................................50
3.1.2 Measuring the Channel Power of Continuously Modulated Signals ............................51
3.1.3 Measuring the Occupied Bandwidth ............................................................................55
3.1.4 Power Measurements on TDMA Signals .....................................................................59
3.1.5 Measuring the Adjacent Channel Leakage Ratio (ACLR) ...........................................62
3.1.6 Measuring the Spectrum Emission Mask ....................................................................71
3.1.7 Measuring the Harmonic Distortion .............................................................................74
3.1.8 Measuring the AM Modulation Depth ..........................................................................76
3.1.9 Measuring Spurious Emissions ...................................................................................78
3.1.10 Working with the Spectrogram Result Display (R&S FSH-K14/ -K15) ........................81
3.1.11 Using Isotropic Antennas .............................................................................................92
3.2 Configuring Spectrum Measurements ....................................................................94
3.2.1 Configuring the Horizontal Axis ...................................................................................94
3.2.2 Configuring the Vertical Axis ........................................................................................98
3.2.3 Setting Bandwidths ....................................................................................................102
3.2.4 Configuring and Triggering the Sweep ......................................................................105
3.2.5 Working with Traces ..................................................................................................111
3.2.6 Using Markers ............................................................................................................116
3.2.7 Using Display Lines ...................................................................................................125
3.2.8 Using Limit Lines........................................................................................................126
3.3 Working with Channel Tables .................................................................................129
3.4 Using Transducer Factors ......................................................................................130
3.4.1 Unit for Measurements with Transducers ..................................................................131
3.4.2 Setting the Reference Level ......................................................................................131
3.4.3 Frequency Range of Transducer ...............................................................................132
3.4.4 Data Sets Containing Transducer Factors ................................................................132