Rohde & Schwarz FSP7 - Replacing Diplexer (30 Ghz) A230; R&S FSP13;30

R&S FSP Module Replacement
1164.4556.82 3.43 E-1
Replacing Diplexer (30 GHz) A230; R&S FSP13/30
(See chapter 5, spare parts list, item 150, and drawing 1164,4391.01.)
In R&S FSP13/30, the module is behind the attenuator on the right-hand side.
Removing Diplexer
 Disconnect cable X71 from motherboard (515).
 Disconnect cables W2 and W30 from diplexer (150).
 Disconnect diplexer (150) from attenuator (30).
 Remove diplexer (150).
Installing Diplexer
 Screw on diplexer (150) to attenuator (30).
 Fasten cables W2 and W30 to diplexer (150).
 Connect cable X71 to motherboard (510).
Completing the Instrument and Frequency Response Correction
 Execute frequency response correction software R&S FSP-FRQ.EXE.
The software is located on the Gloris server.
- Test setup according to menu item "Schematic" (connect external reference).
- Check IEC/IEEE addresses and configuration of instruments.
- Press the Autoselect button and perform the measurement with Run.
- The frequency correction of the YIG filter is performed under item YIG.
- After calibration, the frequency response is corrected over the entire frequency range.
 Create a backup of the EEPROM data (see chapter 2, section "Adjustment of Module Data").