R&S FSP Troubleshooting
1164.4556.82 3.75 E-1
Normal action Error and error cause
If a "bluescreen" is displayed with
loading, a cold start may be
necessary. Proceed as follows in
such a case:
Cold boot (see section
"Performing a Cold Boot" in this
chapter)
Firmware update from the
backup partition, if a cold boot
does not succeed.
(see chapter 4 "Software
Update/Installing Options")
While booting, the detector board is identified again.
If the detector board is not
identified, the following message
is issued:
To Next Page
Loading...
