Front and Rear Panel View
R&S
®
FSVA/FSV
24Quick Start Guide 1321.3066.02 ─ 06
Use the supplied coaxial cable to feed in the LO signal. If no external mix-
ers are connected to the R&S FSVA/FSV, cover the two front connectors
LO OUT / IF IN and IF IN with the SMA caps supplied.
Three-port mixer
1. Connect the LO OUT / IF IN output of the R&S FSVA/FSV to the LO port of
the external mixer.
2. Connect the IF IN input of the R&S FSVA/FSV to the IF port of the external
mixer.
3. Feed the signal to be measured to the RF input of the external mixer.
Front Panel View
To Next Page
Loading...
