Preparing for Use
R&S
®
FSVA/FSV
40Quick Start Guide 1321.3066.02 ─ 06
2. Switch off the power switch on the rear panel of the R&S FSVA/FSV.
3. Switch off the DC power supply.
4. Switch off the battery pack.
4.1.7.1 Charging the Battery Pack
The battery pack is not charged in the factory. The rechargeable batteries must
be charged before they are used for the first time.
The R&S FSVA/FSV‑B34 charger is a standalone charging device which can be
used to charge all four rechargeable batteries of the R&S FSVA/FSV‑B32 battery
pack simultaneously. The rechargeable batteries can be charged at ambient tem-
peratures of 0 °C to +45 °C.
1. Undo the knurled screws (10) on the front of the battery pack and open the
flap (11).
2. Pull the rechargeable batteries (12) by the tab out of the housing.
Figure 4-1: Battery compartment
3. Connect the power cable to the charger.
Putting into Operation
To Next Page
Loading...
