Controlling the R&S FSVA/FSV Remotely
R&S
®
FSVA/FSV
135Quick Start Guide 1321.3066.02 ─ 06
13.Set the "Display the connection bar when I use the full screen" option:
● If activated, a bar showing the network address of the R&S FSVA/FSV will
appear at the top edge of the screen. You can use this bar to reduce, mini-
mize or close the window.
● If deactivated, the only way you can return to the controller desktop from
the R&S FSVA/FSV screen in full screen mode is to select "Disconnect"
from the "Start" menu.
8.1.3 Starting and Terminating Remote Operation
Setting up a connection to the R&S FSVA/FSV
1. In the "Remote Desktop Connection" dialog box (see Chapter 8.1, "Operation
with Windows Remote Desktop ", on page 130), open the "General" tab.
2. In the "Computer" field, enter the IP address of the R&S FSVA/FSV.
In the "User name" field, enter instrument to log in as an administrator, or Nor-
mal User to log in as a standard user.
In the "Password" field, enter 894129.
3. To save the connection configuration for later use:
a) Select the "Save As" button.
The "Save As" dialog box is displayed.
b) Enter the name for the connection information (*.RDP).
4. To load an existing connection configuration:
a) Select the "Open" button.
The "Open" dialog box is displayed.
b) Select the *.RDP file.
5. Select the "Connect" button.
The connection is set up.
6. If the "Drives" option is activated on the "Local Resources" tab, a warning is
displayed indicating that the drives are enabled for access from the
R&S FSVA/FSV.
Select "OK" to confirm the warning.
7. After a few moments, the R&S FSVA/FSV screen is displayed.
Operation with Windows Remote Desktop
To Next Page
Loading...
