Basic Operations
R&S
®
FSVA/FSV
68Quick Start Guide 1321.3066.02 ─ 06
AQT Acquisition time; for ACP/CCDF measurements, IQ analyzer and
option R&S FSV-K7
DBW Demodulation bandwidth option R&S FSV-K7 only
Dig Out State of digital output, option R&S FSV-B17 only
6.1.3 Measurement Settings Information
In addition to the common hardware settings, the channel bar above the diagram
also displays information on instrument settings that affect the measurement
results even though this is not immediately apparent from the display of the mea-
sured values. This information is displayed in gray font and only when applicable
for the current measurement, as opposed to the common hardware settings that
are always displayed.
The following types of information may be displayed, if applicable.
Label Description
SGL The sweep is set to single sweep mode.
Sweep Count The current signal count for measurement tasks that involve a specific number
of subsequent sweeps
(see "Sweep Count" setting in "Sweep" menu in the Operating manual)
TRG Trigger source
(for details see trigger settings in the "TRIG" menu in the Operating manual)
●
EXT: External
●
VID: Video
●
RFP: RF power
●
IFP: IF power
●
BBP: Baseband power
●
PSE: Power sensor
●
TIM: Time
●
SQL: Squelch
6dB/RRC/
CHN
Filter type for sweep bandwidth
(see BW menu in the Operating manual)
PA The preamplifier is activated.
GAT The frequency sweep is controlled via the EXT TRIG/GATE IN connector.
TDF A transducer factor is activated.
Information in the Diagram Area
To Next Page
Loading...
