Firmware Update and Installation of Firmware Options
R&S
®
FSVA/FSV
63Quick Start Guide 1321.3066.02 ─ 06
6. Press "Execute"
The installation program will guide you through the installation.
7. After the firmware update, the "UNCAL" status display indicates the necessity
of a self alignment. Perform a self alignment (for details refer to Chapter 4.1.9,
"Performing a Self Alignment and a Self Test", on page 43).
Remote command: SYST:FIRM:UPD 'D:\FW_UPDATE'
Performing a remote installation from a Windows PC
This method requires a LAN connection from the instrument to a Windows PC
(see Chapter 8.6.1, "Connecting the Instrument to the Network", on page 166).
1. Run the Setup.exe file on your PC.
2. Select "Remote Installation" and click the "Next" button.
3. Select the packages you want to install and click the "Next" button.
4. Your LAN subnet is scanned and all found instruments are listed.
Note: The setup procedure communicates with the instrument via LAN, which
means the file must pass the firewall. Therefore, add the Setup.exe file to
your firewall rules, then restart the scan by clicking "Rescan".
5. Select the instruments you want to update. You can select up to 5 instruments
to update at the same time.
Note: All instruments in your LAN structure are included in the list. Make sure
you select the correct instruments!
To display further options, click the "Options" button.
6. Start installation by clicking "Install".
7. Confirm that you want to reboot the instrument in order to activate the firm-
ware update. The instrument restarts automatically.
5.2 Activating Firmware Options
Firmware options are enabled by entering license keys as described here.
To activate firmware options
1. Press the SETUP key.
Activating Firmware Options
To Next Page
Loading...
