Instrument Functions
R&S
®
FSVA/FSV
282Operating Manual 1176.7510.02 ─ 09
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 664
CALCulate<n>:DELTamarker<m>[:STATe] on page 615
CALCulate<n>:MARKer<m>:TRACe on page 673
CALCulate<n>:DELTamarker<m>:TRACe on page 625
CALCulate<n>:DELTamarker<m>:MREF on page 625
All Marker Off ← Marker Wizard
Switches all markers off. It also switches off all functions and displays that are associ-
ated with the markers/delta markers.
Remote command:
CALCulate<n>:MARKer<m>:AOFF on page 664
All Marker Off
Switches all markers off. It also switches off all functions and displays that are associ-
ated with the markers/delta markers.
Remote command:
CALCulate<n>:MARKer<m>:AOFF on page 664
Marker Table
Defines how the marker information is displayed.
For more information, see Displayed Marker Information.
"On"
Displays the marker information in a table in a separate area beneath
the diagram.
"Off"
Displays the marker information within the diagram area.
"Aut"
(Default) The marker table is displayed automatically if more than 2
markers are active, and removed if only 1 or 2 markers are active.
This helps keep the information in the display clear.
Remote command:
DISPlay:MTABle on page 745
Marker Stepsize
Opens a submenu to set the step size of all markers and delta markers.
Default value for the marker step size is Stepsize Sweep Points.
Stepsize Standard ← Marker Stepsize
Moves the marker or delta marker from one measurement point to the next, if the
marker or delta marker value is changed via the rotary knob ( "Marker 1 / Marker 2 /
Marker 3 / … Marker 16,/ Marker Norm/Delta" softkeys, see "Marker 1 / Marker 2 /
Marker 3 / … Marker 16,/ Marker Norm/Delta" on page 280). If more measured values
than measurement points exist, it is not possible to read out all measured values. In
this case, use the Stepsize Sweep Points softkey.
Remote command:
CALC:MARK:X:SSIZ STAN (see CALCulate<n>:MARKer<m>:X:SSIZe
on page 676)
Measurement Functions
To Next Page
Loading...
