Rohde & Schwarz FSVA - Page 348

Instrument Functions
R&S
®
FSVA/FSV
348Operating Manual 1176.7510.02 ─ 09
Remote command:
[SENSe:]ESPectrum:RANGe<range>:FILTer:TYPE on page 797
RBW ← Sweep List dialog box ← Sweep List ← Spectrum Emission Mask
Sets the RBW value for this range.
Remote command:
[SENSe:]ESPectrum:RANGe<range>:BANDwidth[:RESolution] on page 796
VBW ← Sweep List dialog box ← Sweep List ← Spectrum Emission Mask
Sets the VBW value for this range.
Remote command:
[SENSe:]ESPectrum:RANGe<range>:BANDwidth:VIDeo on page 797
Sweep Time Mode ← Sweep List dialog box ← Sweep List ← Spectrum Emission
Mask
Activates or deactivates the auto mode for the sweep time.
Remote command:
[SENSe:]ESPectrum:RANGe<range>:SWEep:TIME:AUTO on page 803
Sweep Time ← Sweep List dialog box ← Sweep List ← Spectrum Emission Mask
Sets the sweep time value for the range.
Remote command:
[SENSe:]ESPectrum:RANGe<range>:SWEep:TIME on page 803
Ref. Level ← Sweep List dialog box ← Sweep List ← Spectrum Emission Mask
Sets the reference level for the range.
Remote command:
[SENSe:]ESPectrum:RANGe<range>:RLEVel on page 803
RF Att. Mode ← Sweep List dialog box ← Sweep List ← Spectrum Emission
Mask
Activates or deactivates the auto mode for RF attenuation.
Remote command:
[SENSe:]ESPectrum:RANGe<range>:INPut:ATTenuation:AUTO on page 799
RF Attenuator ← Sweep List dialog box ← Sweep List ← Spectrum Emission
Mask
Sets the attenuation value for that range.
Remote command:
[SENSe:]ESPectrum:RANGe<range>:INPut:ATTenuation on page 799
Preamp ← Sweep List dialog box ← Sweep List ← Spectrum Emission Mask
Switches the preamplifier on or off.
Remote command:
[SENSe:]ESPectrum:RANGe<range>:INPut:GAIN:STATe on page 800
Measurement Functions