Quick Start
R&S
®
FSVA/FSV
46Operating Manual 1176.7510.02 ─ 09
●
"NormalUser": a standard user account with limited access
Automatic login
For the administrator account, an automatic login function is active by default. If activa-
ted, login is carried out automatically for the administrator (with full access) in the back-
ground when the R&S FSVA/FSV is started, without having to enter a password. This
function is active until you explicitly deactivate it or change the password.
For information on how to deactivate or re-activate the automatic login, refer to "The
Automatic Login Function" on page 46.
Passwords
For all default user accounts, the initial password is 894129. Note that this password is
very weak, and it is recommended that you change the password for both users after
initial login. You can change the password in Windows 7 for any user at any time via
"Start > Control Panel > User Accounts".
Changing the password and use of auto-login function
Note that when you change the default passwords, the default auto-login function no
longer works! You must re-activate it manually as described in "Re-activating the auto-
matic login function" on page 47.
The Automatic Login Function
When shipped, the instrument is already configured to automatically log on to Win-
dows 7 using the default administrator account ("Instrument") and password.
Deactivating the automatic login function
To deactivate the automatic login function, perform the following steps:
1.
Select the "Windows" icon in the toolbar to access the operating system of the
R&S FSVA/FSV (see also Chapter 2.2.5.4, "Accessing the Start Menu",
on page 47).
2. In the "Start" menu, select "Run".
The "Run" dialog box is displayed.
3. Enter the command C:\R_S\INSTR\USER\NO_AUTOLOGIN.REG.
4. Press the ENTER key to confirm.
The automatic login function is deactivated. The next time you switch on the instru-
ment, you are prompted to enter your user name and password before the firm-
ware is started.
Preparing for Use
To Next Page
Loading...
