Rohde & Schwarz FSVA - Page 662

Remote Control
R&S
®
FSVA/FSV
662Operating Manual 1176.7510.02 ─ 09
Parameters:
<Distance> Numeric value that defines the distance of the shift.
The unit depends on CALCulate<n>:LIMit<k>:UNIT
on page 640.
Example:
CALC:LIM3:UPP:SHIF 20
Shifts all Y values of limit line 3 by 20 limit line units, e.g. dB.
Usage: Event
CALCulate<n>:LIMit<k>:UPPer:SPACing
<InterpolType>
This command selects linear or logarithmic interpolation for the upper limit line.
Suffix:
<n>
.
irrelevant
<k> 1...8
Selects the limit line.
Parameters:
<InterpolType> LINear | LOGarithmic
*RST: LIN
Example:
CALC:LIM:UPP:SPAC LIN
CALCulate<n>:LIMit<k>:UPPer:STATe <State>
This command turns a lower limit line on and off.
Before you can use this command, you have to select a limit line with
CALCulate<n>:LIMit<k>:NAME.
The limit check is activated separately with CALCulate<n>:LIMit<k>:STATe. The
result of the limit check can be queried with CALCulate<n>:LIMit<k>:FAIL?.
Suffix:
<n>
.
irrelevant
<k> 1...8
Selects the limit line.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:LIM4:UPP:STAT ON
Switches on limit line 4 (upper limit).
CALCulate<n>:LIMit<k>:UPPer:THReshold <Threshold>
This command defines a threshold for relative limit lines.
Remote Control – Commands