Rohde & Schwarz FSW Series - 5 Configuration; 5.1 Default Settings for Analog Demodulation

Instrument Tour
R&S
®
FSW
50Getting Started 1338.4102.02 ─ 08
1 2 3
Figure 5-6: Rear panel view - extract 3
1 = Analog baseband interface (option B71)
2 = External generator control (option B10)
3 = Alignment Signal Source (option B2000)
1 2
Figure 5-7: Rear panel view - extract 4
1 = REF INPUT/OUTPUT connectors
2 = OCXO external reference (option B4)
5.2.1 Removable System Hard Drive
The removable system hard drive contains all measurement data from the
R&S FSW, allowing you to store the data securely in an external location.
5.2.2 AC Power Supply Connection and Main Power Switch
An AC power supply connector and main power switch are located in a unit on
the rear panel of the instrument.
Main power switch function:
Position 1: The instrument can be started via the Power key on the front panel.
The (optional) OCXO reference frequency is warmed up.
Position O: The entire instrument is disconnected from the AC power supply.
For details, refer to "Connecting to power" on page 9 and Chapter 4.5, "Connect-
ing the AC Power", on page 19.
Rear Panel View