Rohde & Schwarz FSW Series - Page 102

Configuration
R&S
®
FSW-K7
102User Manual 1173.9240.02 ─ 17
Demodulation Bandwidth............................................................................................ 102
Demodulation Filter.....................................................................................................102
Measurement Time (AQT).......................................................................................... 103
Capture Offset.............................................................................................................103
Resolution Bandwidth................................................................................................. 103
Demodulation Bandwidth
Defines the demodulation bandwidth of the measurement. The demodulation band-
width determines the sampling rate with which the input signal is captured and ana-
lyzed.
For recommendations on finding the correct demodulation bandwidth see chapter 4.2,
"Demodulation Bandwidth", on page 28.
For details on the relation between demodulation bandwidth and sampling rate refer to
chapter 4.3, "Sample Rate, Measurement Time and Trigger Offset", on page 29.
Remote command:
[SENSe:]BANDwidth|BWIDth:DEMod on page 242
Demodulation Filter
Defines the filter to be used for demodulation.
For details on sample rates, measurement times and trigger offsets for various demod-
ulation bandwidths when using a Gaussian filter, see chapter 4.3, "Sample Rate, Mea-
surement Time and Trigger Offset", on page 29.
"Flat"
Default
"Gauss"
Optimizes the settling behaviour of the filter
Remote command:
[SENSe:]BANDwidth|BWIDth:DEMod:TYPE on page 243
Data Acquisition