Rohde & Schwarz FSW Series - Page 112

Configuration
R&S
®
FSW-K7
112User Manual 1173.9240.02 ─ 17
AF Full Span
Sets the span (around the center frequency) of the demodulated data to the maximum
of DBW/2.
Remote command:
[SENSe:]ADEMod:AF:SPAN:FULL on page 259
5.8.2.2 RF Evaluation
These settings are only available for RF evaluation, both in time and frequency
domain. Note that for RF data the center frequency and demodulation bandwidth corre-
spond to the settings defined in the "Input" and "Data Acquisition" configuration.
Center frequency.........................................................................................................112
Span............................................................................................................................112
Demodulation Bandwidth............................................................................................ 113
RF Full Span............................................................................................................... 113
Center frequency
Defines the normal center frequency of the signal. The allowed range of values for the
center frequency depends on the frequency span.
span > 0: span
min
/2 ≤ f
center
≤ f
max
– span
min
/2
f
max
and span
min
are specified in the data sheet.
Remote command:
[SENSe:]FREQuency:CENTer on page 231
Span
Defines the frequency span. The center frequency is kept constant. The following
range is allowed:
span = 0: 0 Hz
span >0:
span
min
≤ f
span
≤ f
max
Demodulation