Configuration
R&S
®
FSW-K7
120User Manual 1173.9240.02 ─ 17
Range
Defines the displayed y-axis range in dB.
The default value is 100 dB.
For Analog Demodulation measurements, time domain scaling is defined in Hz
(default: 500 kHz).
Remote command:
DISPlay[:WINDow<n>]:TRACe:Y[:SCALe] on page 238
Ref Level Position
Defines the reference level position, i.e. the position of the maximum AD converter
value on the level axis in %, where 0 % corresponds to the lower and 100 % to the
upper limit of the diagram.
Only available for RF measurements.
Remote command:
DISPlay[:WINDow<n>]:TRACe:Y[:SCALe]:RPOSition on page 239
Auto Scale Once
Automatically determines the optimal range and reference level position to be dis-
played for the current measurement settings.
The display is only set once; it is not adapted further if the measurement settings are
changed again.
Remote command:
DISPlay[:WINDow<n>]:TRACe:Y[:SCALe]:AUTO ONCE on page 238
Scaling
Defines the scaling method for the y-axis.
"Logarithmic"
Logarithmic scaling (only available for logarithmic units - dB..., and A,
V, Watt)
"Linear Unit"
Linear scaling in the unit of the measured signal
"Linear Per-
cent"
Linear scaling in percentages from 0 to 100
"Absolute"
The labeling of the level lines refers to the absolute value of the refer-
ence level (not available for "Linear Percent")
"Relative"
The scaling is in dB, relative to the reference level (only available for
logarithmic units - dB...). The upper line of the grid (reference level) is
always at 0 dB.
Remote command:
DISPlay[:WINDow<n>]:TRACe:Y:SPACing on page 239
DISPlay[:WINDow<n>]:TRACe:Y[:SCALe]:MODE on page 238
5.8.5 Units
The units define how the demodulated data is displayed. They are configured in the
"Units" tab of the "Demodulation Settings" dialog box.
Demodulation
To Next Page
Loading...
