Rohde & Schwarz FSW Series - Page 177

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
177User Manual 1173.9240.02 ─ 17
<ChannelName> String containing the name of the channel. The channel name is
displayed as the tab label for the measurement channel.
Note: If the specified name for a new channel already exists, the
default name, extended by a sequential number, is used for the
new channel (see INSTrument:LIST? on page 177).
Example:
INST:CRE SAN, 'Spectrum 2'
Adds an additional spectrum display named "Spectrum 2".
INSTrument:CREate:REPLace <ChannelName1>,<ChannelType>,<ChannelName2>
This command replaces a measurement channel with another one.
Parameters:
<ChannelName1> String containing the name of the measurement channel you
want to replace.
<ChannelType> Channel type of the new channel.
For a list of available channel types see INSTrument:LIST?
on page 177.
<ChannelName2> String containing the name of the new channel.
Note: If the specified name for a new channel already exists, the
default name, extended by a sequential number, is used for the
new channel (see INSTrument:LIST? on page 177).
Example:
INST:CRE:REPL 'Spectrum2',IQ,'IQAnalyzer'
Replaces the channel named 'Spectrum2' by a new measure-
ment channel of type 'IQ Analyzer' named 'IQAnalyzer'.
INSTrument:DELete <ChannelName>
This command deletes a measurement channel. If you delete the last measurement
channel, the default "Spectrum" channel is activated.
Parameters:
<ChannelName> String containing the name of the channel you want to delete.
A measurement channel must exist in order to be able delete it.
Example:
INST:DEL 'Spectrum4'
Deletes the spectrum channel with the name 'Spectrum4'.
INSTrument:LIST?
This command queries all active measurement channels. This is useful in order to
obtain the names of the existing measurement channels, which are required in order to
replace or delete the channels.
Activating Analog Demodulation Measurements