Rohde & Schwarz FSW Series - Page 186

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
186User Manual 1173.9240.02 ─ 17
Example:
MIX:LOP 16.0dBm
Manual operation: See "LO Level" on page 62
[SENSe:]MIXer:SIGNal <State>
This command specifies whether automatic signal detection is active or not.
Note that automatic signal identification is only available for measurements that per-
form frequency sweeps (not in vector signal analysis or the I/Q Analyzer, for instance).
Parameters:
<State> OFF | ON | AUTO | ALL
OFF
No automatic signal detection is active.
ON
Automatic signal detection (Signal ID) is active.
AUTO
Automatic signal detection (Auto ID) is active.
ALL
Both automatic signal detection functions (Signal ID+Auto ID)
are active.
*RST: OFF
Manual operation: See "Signal ID" on page 63
See "Auto ID" on page 63
[SENSe:]MIXer:THReshold <Value>
This command defines the maximum permissible level difference between test sweep
and reference sweep to be corrected during automatic comparison (see [SENSe:
]MIXer:SIGNal on page 186).
Parameters:
<Value> <numeric value>
Range: 0.1 dB to 100 dB
*RST: 10 dB
Example:
MIX:PORT 3
Manual operation: See "Auto ID Threshold" on page 63
Mixer Settings
The following commands are required to configure the band and specific mixer set-
tings.
[SENSe:]MIXer:FREQuency:HANDover........................................................................... 187
[SENSe:]MIXer:FREQuency:STARt?................................................................................187
[SENSe:]MIXer:FREQuency:STOP?................................................................................ 187
[SENSe:]MIXer:HARMonic:BAND:PRESet........................................................................188
Configuring the Measurement