Rohde & Schwarz FSW Series - Page 187

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
187User Manual 1173.9240.02 ─ 17
[SENSe:]MIXer:HARMonic:BAND[:VALue]........................................................................188
[SENSe:]MIXer:HARMonic:HIGH:STATe..........................................................................189
[SENSe:]MIXer:HARMonic:HIGH[:VALue]........................................................................ 189
[SENSe:]MIXer:HARMonic:TYPE.....................................................................................189
[SENSe:]MIXer:HARMonic[:LOW]....................................................................................189
[SENSe:]MIXer:LOSS:HIGH............................................................................................190
[SENSe:]MIXer:LOSS:TABLe:HIGH.................................................................................190
[SENSe:]MIXer:LOSS:TABLe[:LOW]................................................................................190
[SENSe:]MIXer:LOSS[:LOW]...........................................................................................190
[SENSe:]MIXer:PORTs...................................................................................................191
[SENSe:]MIXer:RFOVerrange[:STATe]............................................................................ 191
[SENSe:]MIXer:FREQuency:HANDover <Frequency>
This command defines the frequency at which the mixer switches from one range to
the next (if two different ranges are selected). The handover frequency for each band
can be selected freely within the overlapping frequency range.
This command is only available if the external mixer is active (see [SENSe:]MIXer[:
STATe] on page 185).
Parameters:
<Frequency> numeric value
Example:
MIX ON
Activates the external mixer.
MIX:FREQ:HAND 78.0299GHz
Sets the handover frequency to 78.0299 GHz.
Manual operation: See "Handover Freq." on page 60
[SENSe:]MIXer:FREQuency:STARt?
This command queries the frequency at which the external mixer band starts.
Example:
MIX:FREQ:STAR?
Queries the start frequency of the band.
Usage: Query only
Manual operation: See "RF Start / RF Stop" on page 59
[SENSe:]MIXer:FREQuency:STOP?
This command queries the frequency at which the external mixer band stops.
Example:
MIX:FREQ:STOP?
Queries the stop frequency of the band.
Usage: Query only
Manual operation: See "RF Start / RF Stop" on page 59
Configuring the Measurement