Rohde & Schwarz FSW Series - 11.6.2 Working with Windows in the Display

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
283User Manual 1173.9240.02 ─ 17
Parameters:
<Format> SPLit
Displays the MultiView tab with an overview of all active chan-
nels
SINGle
Displays the measurement channel that was previously focused.
*RST: SING
Example:
DISP:FORM SPL
DISPlay[:WINDow<n>]:SIZE <Size>
This command maximizes the size of the selected result display window temporarily.
To change the size of several windows on the screen permanently, use the LAY:SPL
command (see LAYout:SPLitter on page 286).
Parameters:
<Size> LARGe
Maximizes the selected window to full screen.
Other windows are still active in the background.
SMALl
Reduces the size of the selected window to its original size.
If more than one measurement window was displayed originally,
these are visible again.
*RST: SMALl
Example:
DISP:WIND2:LARG
11.6.2 Working with Windows in the Display
The following commands are required to change the evaluation type and rearrange the
screen layout for a measurement channel as you do using the SmartGrid in manual
operation. Since the available evaluation types depend on the selected application,
some parameters for the following commands also depend on the selected measure-
ment channel.
Note that the suffix <n> always refers to the window in the currently selected measure-
ment channel (see INSTrument[:SELect] on page 179).
LAYout:ADD[:WINDow]?.................................................................................................284
LAYout:CATalog[:WINDow]?...........................................................................................285
LAYout:IDENtify[:WINDow]?............................................................................................285
LAYout:REMove[:WINDow].............................................................................................286
LAYout:REPLace[:WINDow]............................................................................................286
LAYout:SPLitter............................................................................................................. 286
LAYout:WINDow<n>:ADD?.............................................................................................288
LAYout:WINDow<n>:IDENtify?........................................................................................288
LAYout:WINDow<n>:REMove.........................................................................................288
LAYout:WINDow<n>:REPLace........................................................................................289
Configuring the Result Display