Rohde & Schwarz FSW Series - Page 312

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
312User Manual 1173.9240.02 ─ 17
Usage: Event
Manual operation: See "Search Minimum" on page 141
CALCulate<n>:DELTamarker<m>:MINimum:RIGHt
This command moves a delta marker to the next higher minimum value.
The search includes only measurement values to the right of the current marker posi-
tion.
Usage: Event
Manual operation: See "Search Mode for Next Peak" on page 140
11.8.1.5 Configuring Special Marker Functions
The following commands are required to configure the special marker functions that
are available in the Analog Demodulation application
.
● Fixed Reference Marker Settings..........................................................................312
● Marker Peak Lists................................................................................................. 314
● n dB Down Marker................................................................................................ 317
● Phase Noise Measurement Marker.......................................................................320
Fixed Reference Marker Settings
The following commands configure a fixed reference marker.
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:MAXimum[:PEAK].................... 312
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:X............................................ 312
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:Y............................................ 313
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:Y:OFFSet................................ 313
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed[:STATe]..............................................313
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:MAXimum[:PEAK]
This command moves the fixed reference marker to the peak power.
Example:
CALC:DELT:FUNC:FIX:RPO:MAX
Sets the reference point level for delta markers to the peak of
the selected trace.
Usage: Event
Manual operation: See "Defining a Fixed Reference" on page 138
See "Defining a Reference Point" on page 144
CALCulate<n>:DELTamarker<m>:FUNCtion:FIXed:RPOint:X <RefPoint>
This command defines the horizontal position of the fixed delta marker reference point.
The coordinates of the reference may be anywhere in the diagram.
Analyzing Results