Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
330User Manual 1173.9240.02 ─ 17
Return values:
<LimitLines> String containing the names of all active limit lines in alphabeti-
cal order.
Example:
CALC:LIM:ACT?
Queries the names of all active limit lines.
Usage: Query only
Manual operation: See "Visibility" on page 149
CALCulate:LIMit<k>:COPY <Line>
This command copies a limit line.
Parameters:
<Line> 1 to 8
number of the new limit line
<name>
String containing the name of the limit line.
Example:
CALC:LIM1:COPY 2
Copies limit line 1 to line 2.
CALC:LIM1:COPY 'FM2'
Copies limit line 1 to a new line named FM2.
Manual operation: See "Copy Line" on page 150
CALCulate:LIMit<k>:DELete
This command deletes a limit line.
Usage:
Event
Manual operation: See "Delete Line" on page 150
CALCulate:LIMit<k>:STATe <State>
This command turns the limit check for a specific limit line on and off.
To query the limit check result, use CALCulate:LIMit<k>:FAIL?.
Note that a new command exists to activate the limit check and define the trace to be
checked in one step (see CALCulate:LIMit<k>:TRACe<t>:CHECk on page 331).
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:LIM:STAT ON
Switches on the limit check for limit line 1.
Usage: SCPI confirmed
Manual operation: See "Disable All Lines" on page 150
Analyzing Results
To Next Page
Loading...
