Rohde & Schwarz FSW Series - Digital I;Q Input Settings

Configuration
R&S
®
FSW-K7
69User Manual 1173.9240.02 ─ 17
5.4.1.3 Digital I/Q Input Settings
The following settings and functions are available to provide input via the Digital Base-
band Interface (R&S FSW-B17) in the applications that support it.
They can be configured via the INPUT/OUTPUT key, in the "Input" dialog box.
For more information see the R&S FSW I/Q Analyzer and I/Q Input User Manual.
Digital I/Q Input State....................................................................................................69
Input Sample Rate........................................................................................................ 69
Full Scale Level.............................................................................................................70
Adjust Reference Level to Full Scale Level...................................................................70
Connected Instrument...................................................................................................70
DigIConf........................................................................................................................ 70
Digital I/Q Input State
Enables or disable the use of the "Digital IQ" input source for measurements. "Digital
IQ" is only available if the Digital Baseband Interface (R&S FSW-B17) is installed.
Remote command:
INPut:SELect on page 184
Input Sample Rate
Defines the sample rate of the digital I/Q signal source. This sample rate must corre-
spond with the sample rate provided by the connected device, e.g. a generator.
If "Auto" is selected, the sample rate is adjusted automatically by the connected
device.
Input and Frontend Settings