Instrument Tour
R&S
®
FSW
56Getting Started 1338.4102.02 ─ 08
5.2.15 External Generator Control Option (R&S FSW-B10)
The external generator control option provides an additional GPIB and an "AUX
control" connector.
The GPIB connector can be used to connect the external generator to the
R&S FSW.
The 9-pole SUB-D female "AUX control" connector is required for TTL synchroni-
zation, if supported by the generator.
For details on connecting an external generator, see the "External Generator
Control" section of the R&S FSW User Manual.
5.2.16 Alignment Signal Source (Option R&S FSW-B2000)
The alignment signal source is required to align the connected oscilloscope and
the oscilloscope ADC for the optional 2 GHz bandwidth extension (R&S FSW-
B2000).
For details, see the R&S FSW I/Q Analyzer and I/Q Input User Manual.
5.2.17 REF INPUT / REF OUTPUT
The REF INPUT connectors are used to provide an external reference signal to
the R&S FSW.
The REF OUTPUT connectors can be used to provide an external reference sig-
nal (or the optional OCXO reference signal) from the R&S FSW to other devices
that are connected to this instrument.
Various connectors are provided for different reference signals:
Rear Panel View
To Next Page
Loading...
