Remote Commands
R&S
®
FSW
770User Manual 1173.9411.02 ─ 19
[SENSe:]LIST:RANGe<range>:INPut:ATTenuation <Attenuation>
This command defines the input attenuation for a spurious emission measurement
range.
Suffix:
<range>
.
1..30
Selects the measurement range.
Parameters:
<Attenuation> Numeric value.
Refer to the data sheet for the attenuation range.
*RST: 10 dB
Default unit: dB
Manual operation: See "RF Attenuator" on page 245
[SENSe:
]LIST:RANGe<range>:INPut:ATTenuation:AUTO <State>
This command turns automatic selection of the input attenuation for a spurious emis-
sion measurement range on and off.
Suffix:
<range>
.
1..30
Selects the measurement range.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Manual operation: See "RF Att. Mode" on page 245
[SENSe:]LIST:RANGe<range>:INPut:GAIN:STATe <State>
This command turns the preamplifier for a spurious emission measurement range on
and off.
The preamplification is defined by [SENSe:]LIST:RANGe<range>:INPut:GAIN[:
VALue] on page 770.
Suffix:
<range>
.
1..30
Selects the measurement range.
Parameters:
<State> ON | OFF
*RST: OFF
Manual operation: See "Preamp" on page 245
[SENSe:]LIST:RANGe<range>:INPut:GAIN[:VALue] <Gain>
This command selects the preamplification level for the range.
Configuring and Performing Measurements
To Next Page
Loading...
