Rohde & Schwarz FSW26 - Page 917

Remote Commands
R&S
®
FSW
917User Manual 1173.9411.02 ─ 19
Manual operation: See "Timestamp" on page 474
CALCulate:SGRam|SPECtrogram:TSTamp[:STATe] <State>
This command activates and deactivates the time stamp.
If the time stamp is active, some commands do not address frames as numbers, but as
(relative) time values:
● CALCulate<n>:DELTamarker<m>:SGRam|SPECtrogram:FRAMe
on page 948
● CALCulate<n>:MARKer<m>:SGRam|SPECtrogram:FRAMe on page 945
● CALCulate:SGRam|SPECtrogram:FRAMe:SELect on page 915
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:SGR:TST ON
Activates the time stamp.
Manual operation: See "Timestamp" on page 474
CALCulate:SGRam|SPECtrogram[:STATe] <State>
This command turns the spectrogram on and off.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:SGR ON
Activates the Spectrogram result display.
Manual operation: See "State" on page 473
Configuring the Color Map
DISPlay[:WINDow<n>]:SGRam|SPECtrogram:COLor:DEFault........................................... 917
DISPlay[:WINDow<n>]:SGRam|SPECtrogram:COLor:LOWer.............................................918
DISPlay[:WINDow<n>]:SGRam|SPECtrogram:COLor:SHAPe............................................ 918
DISPlay[:WINDow<n>]:SGRam|SPECtrogram:COLor:UPPer............................................. 918
DISPlay[:WINDow<n>]:SGRam|SPECtrogram:COLor[:STYLe]........................................... 918
DISPlay[:WINDow<n>]:SGRam|SPECtrogram:COLor:DEFault
This command restores the original color map.
Usage:
Event
Manual operation: See "Set to Default" on page 477
Analyzing Measurements (Basics)