Rohde & Schwarz FSW43 - Page 1052

Remote Commands
R&S
®
FSW
1052User Manual 1173.9411.02 ─ 19
Manual operation: See "Language" on page 653
See "Wideband" on page 654
SYSTem:REVision:FACTory
Resets the response to the REV? query to the default value, e.g. after a user string
was defined using the SYSTem:REVision[:STRing] command. (REV? query availa-
ble for HP emulation only, see SYSTem:LANGuage on page 1050.)
Example: Define the system language:
SYST:LANG '8563E'
Set the response back to factory setting:
SYS:REV:FACT
Query the revision:
REV?
Response:
920528
Manual operation: See "Resetting the Factory Revision" on page 655
SYSTem:REVision[:STRing] <Name>
Sets the response to the REV? query to the defined string (HP emulation only, see
SYSTem:LANGuage on page 1050).
Parameters:
<Name>
Example: Define the system language:
SYST:LANG '8563E'
Query the revision:
REV?
Response:
920528
Set the response to 'NewRevision':
SYST:REV:STR 'NewRevision'
Query the response:
SYST:REV:STR?
Response:
NewRevision
Manual operation:
See "Revision String" on page 655
SYSTem:RSW <State>
Controls a repeated sweep of the E1 and MKPK HI HP model commands (for details
on the commands refer to chapter 11.13.2, "Reference: GPIB Commands of Emulated
HP Models", on page 1053). If the repeated sweep is OFF, the marker is set without
sweeping before.
Emulating Other Instruments' Commands