Configuration
R&S
®
FSWP
47User Manual 1177.5856.02 ─ 07
Level ← Output Type ← Trigger 1/2
Defines whether a high (1) or low (0) constant signal is sent to the trigger output con-
nector.
The trigger pulse level is always opposite to the constant signal level defined here. For
example, for "Level = High", a constant high signal is output to the connector until you
select the Send Trigger function. Then, a low pulse is provided.
Remote command:
OUTPut<up>:TRIGger<tp>:LEVel on page 125
Pulse Length ← Output Type ← Trigger 1/2
Defines the duration of the pulse (pulse width) sent as a trigger to the output connector.
Remote command:
OUTPut:TRIGger<tp>:PULSe:LENGth on page 126
Send Trigger ← Output Type ← Trigger 1/2
Sends a user-defined trigger to the output connector immediately.
Note that the trigger pulse level is always opposite to the constant signal level defined
by the output Level setting. For example, for "Level" = "High", a constant high signal is
output to the connector until you select the "Send Trigger" function. Then, a low pulse
is sent.
Which pulse level will be sent is indicated by a graphic on the button.
Remote command:
OUTPut:TRIGger<tp>:PULSe:IMMediate on page 126
5.4 Configuring the Amplitude
The amplitude is configured in the "Amplitude" dialog box. Amplitude settings are simi-
lar to those of the Spectrum application, except for a few functions
● Configuring Level Characteristics........................................................................... 47
● Scaling the Level Axis.............................................................................................51
5.4.1 Configuring Level Characteristics
Access: "Overview" > "Amplitude" > "Amplitude"
Configuring the Amplitude
To Next Page
Loading...
