Rohde & Schwarz FSWP26 - 5.6 Configuring Triggered Measurements; Trigger Source; Trigger Level

Configuration
R&S
®
FSWP
54User Manual 1177.5856.02 ─ 07
Remote command:
[SENSe:]FREQuency:OFFSet on page 119
5.6 Configuring Triggered Measurements
Access (trigger source): "Overview" > "Trigger / Gate" > "Trigger Source"
Access (trigger connectors): "Overview" > "Trigger / Gate" > "Trigger In / Out"
Trigger settings determine when the input signal is measured.
Conventional gating as in the Spectrum application is not available for the I/Q Ana-
lyzer; however, a special gating mode is available in remote control, see Chap-
ter 8.6.10, "Configuring Gated Measurements", on page 126.
For step-by-step instructions on configuring triggered measurements, see the user
manual of the spectrum application.
Functions to configure trigger output described elsewhere:
●
"Trigger 1/2" on page 46
The remote commands required to configure triggered measurements are described in
Chapter 8.6.8, "Configuring Trigger", on page 119.
Trigger Source ..............................................................................................................55
└ Free Run ........................................................................................................55
└ Ext. Trigger 1/2............................................................................................... 55
└ IF Power .........................................................................................................55
└ I/Q Power .......................................................................................................56
└ RF Power .......................................................................................................56
└ Time ............................................................................................................... 56
Trigger Level ................................................................................................................ 56
Repetition Interval ........................................................................................................ 57
Trigger Offset ............................................................................................................... 57
Hysteresis .................................................................................................................... 57
Configuring Triggered Measurements