Antenna Interface - Removal and Installation R&S M3SR Series 4100 HF Transceivers
5.27 6124.9007.82.01
5.12 Antenna Interface - Removal and Installation
5.12.1 Removal of the Antenna Interface
To remove the Antenna Interface from the R&S M3SR Series 4100 150 W HF Transceiver proceed as
follows (see also Fig. 5.17):
1. Take off the top cover of the R&S M3SR Series 4100 150 W HF Transceiver as described in
5.1 - Disassembly.
2. Disconnect RF cable W2111 from connector X2 at Frontend (A1).
3. At the transceiver rear, undo and remove the two screws fixing the Antenna Interface.
4. Carefully take Antenna Interface off to the rear.
Fig. 5.17 Removing the Antenna Interface
5.12.2 Installation of the Antenna Interface
To install a new Antenna Interface proceed as follows:
1. Install the Antenna Interface in reverse order of removal.
2. Close the R&S M3SR Series 4100 150 W HF Transceiver in reverse order as described in
5.1 - Disassembly.
ICN-S4100-A-E11100-R-D0894-00127-A-01-1
To Next Page
Loading...
