Acquisition and waveform setupMXO 4 Series
120User Manual 1335.5337.02 ─ 07
Show channel
Switches the selected channel signal on or off.
The signal icon opens on the signal bar. The waveform of the last acquisition is dis-
played in the diagram.
Remote command:
CHANnel<ch>:STATe on page 509
Signal flow (graphical button)
Opens a dialog that shows the signal flow as currently configured. In addition, the main
settings are shown for information.
Vertical scale
Sets the vertical scale, which defines the displayed amplitude of the selected wave-
form.
The unit depends on the connected probe.
Vertical setup
To Next Page
Loading...
