Rohde & Schwarz MXO 4 Series - Trigger Information

TriggerMXO 4 Series
141User Manual 1335.5337.02 ─ 07
Action on trigger
A trigger can initiate a trigger out signal.
Trigger sequence
A trigger sequence joins two or more separate trigger conditions with an optional delay
time and an optional reset time or reset condition. Similar setups are also known as
multi-step triggers or A/B trigger.
7.1.1 Trigger information
Information on the most important trigger settings is shown in the trigger label above
the diagram. If you tap the trigger label, the "Trigger" dialog opens.
If you trigger on a single event, the trigger label shows:
●
Trigger source
●
Trigger type
●
Trigger level
●
Trigger mode
●
Edge or polarity, and important trigger-type specific settings
●
Trigger state
Figure 7-1: Trigger label on the toolbar
1 = Trigger source
2 = Trigger type
3 = Trigger level
4 = Trigger mode
5 = Trigger state
6 = Trigger type specific settings
7 = Trigger slope
If you trigger on a sequence, the trigger label shows:
●
Sequence type
●
Trigger mode
●
Trigger state
Basics of triggering