TriggerMXO 4 Series
148User Manual 1335.5337.02 ─ 07
The "Slope" and "Level" are the same settings as for the edge trigger, see:
●
"Level" on page 143
●
"Slope" on page 147
Specific settings for the analog edge trigger are the following:
Coupling
Sets the connection of the external trigger signal, i.e. the input impedance and a termi-
nation. The coupling determines what part of the signal is used for triggering.
"DC 50
Ω"
Connection with 50 Ω termination, passes both DC and AC compo-
nents of the signal.
"DC 1 MΩ"
Connection with 1 MΩ termination, passes both DC and AC compo-
nents of the signal.
Trigger types
To Next Page
Loading...
