TriggerMXO 4 Series
151User Manual 1335.5337.02 ─ 07
You need to know the expected pulse widths of the circuit to set the glitch width cor-
rectly.
Remote command:
TRIGger:EVENt<ev>:GLITch:WIDTh on page 547
7.4.4 Width trigger
Access: "Menu" > "Trigger" > "Setup" tab > "Type = Width"
The width trigger compares the pulse width (duration) with given time limits. It detects
pulses with an exact pulse width, pulses shorter or longer than a given time, and also
pulses inside or outside the allowable time range. The pulse width is measured at the
trigger level.
This section describes the trigger-type specific settings. For settings that apply to all
trigger types, see Chapter 7.2, "Common trigger settings", on page 142.
Level
See "Level" on page 143.
Remote command:
TRIGger:EVENt<ev>:LEVel<n>[:VALue] on page 541
Trigger types
To Next Page
Loading...
