TriggerMXO 4 Series
164User Manual 1335.5337.02 ─ 07
1. Select the "Clock Source" and the "Slope".
2. Tap "Set state".
See Chapter 7.4.12.2, "Set state for state and pattern trigger of analog channels",
on page 166 for setting details.
Slope
Sets the edge direction for the trigger.
"Positive"
Selects the rising edge, which is a positive voltage change.
"Negative"
Selects the falling edge, which is a negative voltage change.
"Either"
Selects the rising and falling edge. After starting an acquisition, the
instrument triggers on the first identified edge.
Remote command:
TRIGger:EVENt<ev>:STATe:SLOPe on page 562
7.4.12 Pattern trigger
Access: "Menu" > "Trigger" > "Setup" tab > "Type = Pattern"
The pattern trigger works like a logic trigger. It provides logical combinations of the
input channels and can be used for verifying the operation of digital logic. If the chan-
nel states match the desired pattern, the pattern trigger occurs.
This section describes the trigger-type specific settings. For settings that apply to all
trigger types, see Chapter 7.2, "Common trigger settings", on page 142.
Trigger types
To Next Page
Loading...
