Rohde & Schwarz MXO 4 Series - Line Trigger; Trigger Mode; Holdoff

TriggerMXO 4 Series
169User Manual 1335.5337.02 ─ 07
●
"AND": logical AND, conjunctive combination
●
"OR": logical OR, disjunctive combination
Remote command:
TRIGger:EVENt<ev>:STATe:QUALify:LOGic on page 562
TRIGger:EVENt<ev>:PATTern:QUALify:LOGic on page 564
TRIGger:EVENt<ev>:PATTern:QUALify:DIGital:LOGic on page 564
TRIGger:EVENt<ev>:STATe:QUALify:DIGital:LOGic on page 562
7.4.13 Line trigger
Access: "Menu" > "Trigger" > "Setup" tab > "Source" = "Line"
The line trigger is an edge trigger that triggers on the AC power input and synchronizes
the signal to the AC power frequency. It is not a trigger type but rather a special trigger
source. Use the line source if you want to analyze signals related to the power line fre-
quency, such as lighting equipment and power supply devices.
Slope
Selects the rising or falling edges of the AC power input.
Remote command:
TRIGger:EVENt<ev>:EDGE:SLOPe on page 544
7.5 Trigger mode / holdoff
Access: "Trigger" menu > "Mode / holdoff" tab
Holdoff conditions define a waiting time after the current trigger until the next trigger
can be recognized.
Trigger mode / holdoff