Waveform analysisMXO 4 Series
191User Manual 1335.5337.02 ─ 07
Scale mode
By default, the vertical scale is adapted to the current measurement results automati-
cally to provide an optimal display. However, if necessary, you can define scaling val-
ues manually to suit your requirements.
"Manual"
Enter the required values for "Vertical scale" and "Vertical offset".
"Auto"
"Vertical scale" and "Vertical offset" are read-only.
Remote command:
CALCulate:MATH<m>:VERTical:SCALe:MODE on page 585
Vertical scale
Sets the scale of the y-axis in the math function diagram. The value is defined as
"<unit> per division", e.g. 50
mV/div. In this case, the horizontal grid lines are displayed
in intervals of 50 mV.
If Scale mode is set to "Auto", this setting is read-only.
Remote command:
CALCulate:MATH<m>:VERTical:SCALe[:VALue] on page 584
Vertical offset
Sets a voltage offset to adjust the vertical position of the math function on the screen.
Negative values move the waveform up, positive values move it down.
If Scale mode is set to "Auto", this setting is read-only.
Remote command:
CALCulate:MATH<m>:VERTical:OFFSet on page 584
Unit
Sets a user-defined unit for the math operation.
Remote command:
CALCulate:MATH<m>:UNIT on page 584
Mathematics
To Next Page
Loading...
