Waveform analysisMXO 4 Series
195User Manual 1335.5337.02 ─ 07
Display time
Sets the display time for one acquisition. The shorter the time, the faster the replay is.
The setting takes effect for usual history replay and the display of a fast segmentation
series via the history.
Remote command:
ACQuire:HISTory:TPACq on page 588
Time stamp
The time stamp shows the time of the currently displayed history acquisition. Thus, the
time relation between acquisitions is always available.
The time stamp "Mode" can be absolute or relative:
●
In "Absolute" mode, the instrument shows the date and the daytime of the current
acquisition.
●
In "Relative" mode, the time difference to the newest acquisition (index = 0) is
shown.
During history replay, the time value is displayed and updated if the replay speed ("Dis-
play time") is slow enough, that is 40 ms or slower.
The quick-access history dialog box always shows the time according to the "Mode"
that is selected in the "Acquisition" > "History" tab.
Remote command:
ACQuire:HISTory:TSDate? on page 589
ACQuire:HISTory:TSABsolute? on page 588
ACQuire:HISTory:TSRelative? on page 589
ACQuire:HISTory:TSRReference? on page 589
8.3.3 Quick access history dialog
The quick access history dialog is visible when the history is active. Closing the dialog
disables the history display ("Show history" = "Off")
Available acqs............................................................................................................. 196
Current acq................................................................................................................. 196
Time............................................................................................................................ 196
Auto repeat..................................................................................................................196
Play............................................................................................................... 196
History
To Next Page
Loading...
