Waveform analysisMXO 4 Series
200User Manual 1335.5337.02 ─ 07
In the "Setup" tab, you select the target reference waveform and its source.
R1/2/3/4
Each tab contains the settings for one of the available reference waveforms.
Show
Enables the display of the reference waveform in the diagram.
Remote command:
REFCurve<rc>:STATe on page 592
Source
Selects the source waveform from the active waveforms, e.g. input channels, math
waveforms, or spectrum.
Remote command:
REFCurve<rc>:SOURce on page 592
Reference waveforms
To Next Page
Loading...
