Waveform analysisMXO 4 Series
203User Manual 1335.5337.02 ─ 07
Waveform arithmetic
The waveform arithmetic is taken from the source waveform of the reference, and it
cannot be changed for the reference. Waveform arithmetic builds the resulting wave-
form from several consecutive acquisitions of the signal. The arithmetic methods are
envelope and average, which are set in the Acquisition mode.
Restore settings
Applies the original settings of the reference waveform to the horizontal and vertical
settings of the selected waveform.
Remote command:
REFCurve<rc>:RESTore on page 591
8.4.2.3 Reference waveform vertical
Access: [Ref] key > "Vertical" tab
Mode
Selects the type of vertical settings:
"Coupled to
source"
Vertical position and scale of the source are used.
"Independent"
Scaling and position can be set specific to the reference waveform.
Remote command:
REFCurve<rc>:VMODe on page 597
Set to original
Available, if "Mode" = "Independent".
Restores the original vertical settings of the reference waveform (vertical scale, posi-
tion, and offset).
Remote command:
REFCurve<rc>:TOORiginal on page 596
Reference waveforms
To Next Page
Loading...
