Waveform analysisMXO 4 Series
204User Manual 1335.5337.02 ─ 07
Vertical scale
Available, if "Mode" = "Independent".
Sets the vertical scale, which defines the displayed amplitude of the selected wave-
form.
The unit of the reference is the same as the unit of the source waveform.
Remote command:
REFCurve<rc>:SCALe on page 593
Vertical offset
The vertical offset moves the reference waveform vertically. Enter a value with the unit
of the waveform.
Remote command:
REFCurve<rc>:OFFSet on page 591
Vertical position
Available, if "Mode" = "Independent".
Moves the reference waveform up or down in the diagram.
Remote command:
REFCurve<rc>:POSition on page 594
8.4.2.4 Reference waveform rescale
Access: [Ref] key > "Rescale" tab
Reference waveforms
To Next Page
Loading...
