MeasurementsMXO 4 Series
211User Manual 1335.5337.02 ─ 07
Cu1/Cu2
The settings for each cursor measurement (or cursor set) are configured on separate
tabs. For each cursor set, a horizontal pair of cursors, a vertical pair of cursors, or both
can be displayed.
Show cursor
Enables the selected cursor measurement.
Remote command:
CURSor<cu>:STATe on page 635
Cursor style
Defines how the cursor is displayed in the diagram.
"Lines"
The cursors are displayed as lines.
"Line & Rhombus"
The cursors are displayed as lines. The intersections of the cursors
with the waveforms are displayed by rhombus-shaped points.
Cursor measurements
To Next Page
Loading...
